| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
R5F72115D160FPV bảng dữ liệu(PDF) 97 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
R5F72115D160FPV bảng dữ liệu(HTML) 97 Page - Renesas Technology Corp |
|
97 / 1228 page ![]() Section 4 Clock Pulse Generator (CPG) Rev. 2.00 May. 08, 2008 Page 73 of 1200 REJ09B0344-0200 4.5 Changing the Frequency The frequency of the internal clock (I φ) and peripheral clock (Pφ) can be changed either by changing the multiplication rate of PLL circuit 1 or by changing the division rates of divider. All of these are controlled by software through the frequency control register (FRQCR). The methods are described below. 4.5.1 Changing the Multiplication Rate A PLL settling time is required when the multiplication rate of PLL circuit 1 is changed. When the multiplication rate is changed, the LSI temporarily stops automatically and the internal watchdog timer (WDT) starts counting the settling time. When the count of the WDT overflows, the LSI restarts operating with the set clock frequency. The following shows this setting procedure. 1. In the initial state, the multiplication rate of PLL circuit 1 is 1 time. 2. Set a value that will become the specified oscillation settling time in the WDT and stop the WDT. The following must be set: WTCSR.TME = 0: WDT stops WTCSR.CKS[2:0]: Division ratio of WDT count clock WTCNT counter: Initial counter value For setting of the counter, determine the overflow period with the frequency after the peripheral clock (P φ) setting change. 3. Set the desired value in the STC[1:0] bits. The division ratio can also be set in the IFC[2:0] and PFC[2:0] bits. 4. This LSI pauses temporarily and the WDT starts incrementing. The internal and peripheral clocks both stop and the WDT is supplied with the clock. The clock will continue to be output at the CK pin. This state is the same as software standby mode. Whether or not registers are initialized depends on the module. For details, see table 23.4 in section 23, Power-Down Modes. 5. Supply of the clock that has been set begins at WDT count overflow, and this LSI begins operating again. The WDT stops counting after it overflows. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |