NRF52810-QFAA-R datasheet(204/483 Pages) NORDIC

204 / 483 page

Peripherals

6.10.5 Hardware example

Connect the microphone clock to CLK, and data to DIN.

CLK

Vdd

DATA

L/R

CLK

DIN

nRFxxxxx

CLK

DIN

Figure 42: Example of a single PDM microphone, wired as left

CLK

Vdd

DATA

L/R

CLK

DIN

nRFxxxxx

CLK

DIN

Figure 43: Example of a single PDM microphone, wired as right

Note that in a single-microphone (mono) configuration, depending on the microphone’s implementation,

either the left or the right channel (sampled at falling or rising CLK edge respectively) will contain reliable

data. If two microphones are used, one of them has to be set as left, the other as right (L/R pin tied high or

to GND on the respective microphone). It is strongly recommended to use two microphones of exactly the

same brand and type so that their timings in left and right operation match.

CLK

Vdd

DATA

L/R

CLK

DIN

nRFxxxxx

CLK

Vdd

DATA

L/R

CLK

DIN

Figure 44: Example of two PDM microphones

6.10.6 Pin configuration

The CLK and DIN signals associated to the PDM module are mapped to physical pins according to the

configuration specified in the PSEL.CLK and PSEL.DIN registers respectively. If the CONNECT field in any

PSEL register is set to Disconnected, the associated PDM module signal will not be connected to the

required physical pins, and will not operate properly.

The PSEL.CLK and PSEL.DIN registers and their configurations are only used as long as the PDM module is

enabled, and retained only as long as the device is in System ON mode. See POWER — Power supply on

page 61 for more information about power modes. When the peripheral is disabled, the pins will behave

as regular GPIOs, and use the configuration in their respective OUT bit field and PIN_CNF[n] register.

To ensure correct behaviour in the PDM module, the pins used by the PDM module must be configured

in the GPIO peripheral as described in GPIO configuration before enabling peripheral on page 205

before enabling the PDM module. This is to ensure that the pins used by the PDM module are driven

correctly if the PDM module itself is temporarily disabled or the device temporarily enters System OFF.

4430_161 v1.0

204

NRF52810-QFAA-R bảng dữ liệu(PDF) 204 Page - Nordic Semiconductor

NRF52810-QFAA-R bảng dữ liệu(HTML) 204 Page - Nordic Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL