NRF52810-QFAA-R datasheet(54/483 Pages) NORDIC

54 / 483 page

Core components

Some peripherals will behave differently in debug interface mode compared to normal mode. These

differences are described in more detail in the chapters of the peripherals that are affected.

When a debug session is over, the external debugger must make sure to put the device back into normal

mode since the overall power consumption will be higher in debug interface mode compared to normal

mode.

For details on how to use the debug capabilities please read the debug documentation of your IDE.

If the device is in System OFF when power is requested via CxxxPWRUPREQ, the system will wake up and

the DIF flag in RESETREAS on page 68 will be set.

4.8.4 Real-time debug

The nRF52810 supports real-time debugging.

Real-time debugging will allow interrupts to execute to completion in real time when breakpoints are set

in Thread mode or lower priority interrupts. This enables the developer to set a breakpoint and single-

step through their code without a failure of the real-time event-driven threads running at higher priority.

For example, this enables the device to continue to service the high-priority interrupts of an external

controller or sensor without failure or loss of state synchronization while the developer steps through

code in a low-priority thread.

4430_161 v1.0

NRF52810-QFAA-R bảng dữ liệu(PDF) 54 Page - Nordic Semiconductor