CMV2000 datasheet(46/87 Pages) AMSOSRAM

46 / 87 page

CMV2000

Functional description

Datasheet

• PUBLIC • Document Feedback

DS000734

• v8-00 • 2025-Jul-07

46 / 87

Bit

Function

Description

[10]

‘0’

Constant zero

[11]

‘0’

Constant zero

(1) The status bits are purely informational. These bits are not required to know when the data is valid. The DVAL, LVAL and

FVAL signals are sufficient to know when to sample the image data.

INTE1/2 will be low when FOT is high, so the exposure during the small 0.43*reg73 overlap

(see formulas in 7.4.1), will not be visible in the INTE1/2 bits.

Pins H2 (TDIG1) and G2 (TDIG2) can be programmed to map the state of control channel bits

[0] (DVAL), [1] (LVAL), [2] (FVAL), [6] (INTE1) or [7] (INTE2) with registers 108 (T_dig1) and

109 (T_dig2).

Table 10: Register 108/109 value

TDIG1

TDIG2

INTE1

INTE2

DVAL

LVAL

FVAL

7.3.5.1

DVAL, LVAL, FVAL

The first three bits of the control word must be used to identify valid data and the read-out

status.

Figure 42 shows the timing of the DVAL, LVAL and FVAL bits of the control channel with an

example of the read-out of a frame of 3 rows (default is 1088 rows). This example uses the

default mode of 16 outputs in 10-bit mode.

Figure 42: DVAL, LVAL and FVAL timing in 16 outputs mode

IDLE

128

DATA_OUT

DVAL

LVAL

FVAL

CMV2000 bảng dữ liệu(PDF) 46 Page - ams-OSRAM AG

CMV2000 bảng dữ liệu(HTML) 46 Page - ams-OSRAM AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

bảng dữ liệu tải về

Link URL