 |
công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
|
công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
SMS01GAF bảng dữ liệu(PDF) 42 Page - Numonyx B.V |
|
|
|||||||||||||||||||||||||||||
SMS01GAF bảng dữ liệu(HTML) 42 Page - Numonyx B.V |
|
|
42 / 61 page  Serial peripheral interface (SPI) mode SMSxxxAF, SMSxxxFF, SMSxxxBF 42/61 7 Serial peripheral interface (SPI) mode The SPI mode is a secondary communication protocol, which is available in Flash memory- based SD Memory Cards. The SD Memory Card SPI implementation uses a subset of the SD Memory Card protocol and command set. The advantage of the SPI mode is the capability of using off-the-shelf host, hence reducing the design-in effort to a minimum. The disadvantage is the loss of performance (e.g., Single data line and hardware CS signal per card). The SPI mode is selected during the first Reset command after power-up (CMD0) and cannot be changed once the part is powered on. 7.1 SPI bus topology The SPI compatible communication mode of the SD Memory Card is designed to communicate with an SPI channel, commonly found in various microcontrollers on the market. The SPI standard defines the physical link only, and not the complete data transfer protocol. The SD Memory Card SPI and SD modes use the same command set. Like all SPI devices, the SD Memory Card SPI channel uses the four following signals: ● CS: Host to card Chip Select signal. ● CLK: Host to card clock signal ● DataIn: Host to card data signal. ● DataOut: Card to host data signal. All data tokens are multiples of Bytes (8 bits) and always Byte-aligned to the CS signal. The card identification and addressing methods are replaced by a hardware Chip Select (CS) signal. There are no broadcast commands. For every command, a card (slave) is selected by asserting (active Low) the CS signal (see Figure 31: SD Memory Card System SPI Mode Bus Topology).The CS signal must be continuously active for the duration of the SPI transaction. The only exception occurs during card programming, when the host can de- assert the CS signal without affecting the programming process. The SPI interface uses 7 out of the 9 SD signals (DAT1 and DAT2 are not used, DAT3 is the CS signal) of the SD bus. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Vietnamese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
