TMS320DM355 datasheet(84/153 Pages) TI

84 / 153 page

www.ti.com

Boot

mode

Reset

Boot

mode

Bootfrom

NANDflash

InternalROM

BootOK?

Yes

Bootfrom

UART

Bootfrom

MMC/SD

BootOK?

Yes

Invokeloaded

Program

Invoke

NorFlash

OrOneNAND

Yes

3.13 Power Management

TMS320DM355

Digital Media System-on-Chip (DMSoC)

SPRS463 – SEPTEMBER 2007

–

Support for up to 30KB UBL (32KB - ~2KB for RBL stack)

• ARM ROM Boot - UART mode

–

No support for a full firmware boot. Instead, loads a second stage user boot loader (UBL) via UART

to ARM internal RAM (AIM) and transfers control to the user software.

–

Support for up to 30KB UBL (32KB - ~2KB for RBL stack)

The general boot sequence is shown in Figure 3-6. For more information, refer to the ARM Subsystem

User's Guide.

Figure 3-6. Boot Mode Functional Block Diagram

The is designed for minimal power consumption. There are two components to power consumption: active

power and leakage power. Active power is the power consumed to perform work and scales with clock

frequency and the amount of computations being performed. Active power can be reduced by controlling

the clocks in such a way as to either operate at a clock setting just high enough to complete the required

operation in the required timeline or to run at a clock setting until the work is complete and then drastically

cut the clocks (e.g. to PLL Bypass mode) until additional work must be performed. Leakage power is due

Detailed Device Description

Submit Documentation Feedback

TMS320DM355 bảng dữ liệu(PDF) 84 Page - Texas Instruments

TMS320DM355 bảng dữ liệu(HTML) 84 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL