USB97C100QFP datasheet(51/64 Pages) SMSC

51 / 64 page

SMSC DS – USB97C100

Page 51

Rev. 01/03/2001

DC PARAMETERS

MAXIMUM GUARANTEED RATINGS

Operating Temperature Range ...........................................................................................................................0

oC to +70oC

Storage Temperature Range ........................................................................................................................... -55

o to +150oC

Lead Temperature Range (soldering, 10 seconds).....................................................................................................+325

Positive Voltage on any pin, with respect to Ground .................................................................................................Vcc+0.3V

Negative Voltage on any pin, with respect to Ground .................................................................................................... -0.3V

Maximum Vcc ..................................................................................................................................................................... +7V

*Stresses above the specified parameters could cause permanent damage to the device. This is a stress rating only

and functional operation of the device at any other condition above those indicated in the operation sections of this

specification is not implied.

Note: When powering this device from laboratory or system power supplies, it is important that the Absolute Maximum

Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage spikes on their outputs when

the AC power is switched on or off. In addition, voltage transients on the AC power line may appear on the DC output.

When this possibility exists, it is suggested that a clamp circuit be used.

DC ELECTRICAL CHARACTERISTICS (TA = 0°C - 70°C, Vcc = +3.3 V ± 10%)

PARAMETER

SYMBOL

MIN

TYP

MAX

UNITS

COMMENTS

I Type Input Buffer

Low Input Level

High Input Level

VILI

VIHI

2.0

0.8

TTL Levels

ICLK Input Buffer

Low Input Level

High Input Level

VILCK

VIHCK

2.2

0.4

Input Leakage

(All I and IS buffers)

Low Input Leakage

High Input Leakage

IIL

IIH

-10

+10

VIN = 0

VIN = VCC

O8 Type Buffer

Low Output Level

High Output Level

Output Leakage

VOL

VOH

IOL

2.4

-10

0.4

+10

IOL = 8 mA @ VCC =

IOL = 4 mA @ VCC =

3.3V

IOH = -4 mA @ VCC

= 5V

IOH = -2 mA @ VCC

= 3.3V

VIN = 0 to VCC

(Note 1)

USB97C100QFP bảng dữ liệu(PDF) 51 Page - SMSC Corporation

USB97C100QFP bảng dữ liệu(HTML) 51 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

bảng dữ liệu tải về

Link URL