WM9707

Production Data

w

PD Rev 4.1 June 2006

22

SYNC

BITCLK

SDATAIN

CODEC

READY

SLOT (1)

SLOT (2)

WM9703 SAMPLES

SYNC ASSERTION HERE

AC'97 CONTROLLER

SAMPLES FIRST SDATA_IN

BIT OF FRAME HERE

END OF PREVIOUS AUDIO FRAME

Figure 15 Start of an Audio Input Frame

A new audio input frame begins with a low to high transition of SYNC as shown in Figure 15. SYNC

is synchronous to the rising edge of BITCLK. On the immediately following falling edge of BITCLK,

AC’97 samples the assertion of SYNC. This falling edge marks the time when both sides of AC-link

are aware of the start of a new audio frame.

On the next rising of BITCLK, AC’97 transitions

SDATAIN into the first bit position of slot 0 (“CODEC Ready” bit). Each new bit position is presented

to AC-link on a rising edge of BITCLK, and subsequently sampled by the AC’97 Controller on the

following falling edge of BITCLK.

This sequence ensures that data transitions and subsequent

sample points for both incoming and outgoing data streams are time aligned.

SDATAIN’s composite stream is MSB justified (MSB first) with all non-valid bit positions (for assigned

and/or unassigned time slots) stuffed with 0s by the WM9707. SDATAIN should be sampled on the

falling edges of BITCLK.

SLOT 1: STATUS ADDRESS PORT

The status port is used to monitor status for the WM9707 functions including, but not limited to, mixer

settings, and power management.

Audio input frame slot 1 echoes the control register index, for historical reference, for the data to

be returned in slot 2. (Assuming that slots 1 and 2 had been tagged valid by the WM9707 during slot

0).

STATUS ADDRESS PORT BIT ASSIGNMENTS:

Bit (19)

RESERVED (stuffed with 0s)

Bit (18:12)

Control register index (echo of register index for which data is

being returned)

Bit (11:2)

Variable sample rate SLOTREQ bits.

Bit (1:0)

RESERVED (stuffed with 0s)

The first bit (MSB) generated by the WM9707 is always stuffed with a 0. The following 7 bit positions

communicate the associated control register address. The next 10 bits support the AC’97 Rev 2.1

variable sample rate signalling protocol, and the trailing 2 bit positions are stuffed with 0s by AC’97.

SLOT 2: STATUS DATA PORT

The status data port delivers 16-bit control register read data.

Bit (19:4)

Control register read data (stuffed with 0s if tagged invalid by

WM9701)

Bit (3:0)

RESERVED (stuffed with 0s)

If slot 2 is tagged invalid by the WM9707, then the entire slot will be stuffed with 0s by the WM9707.

SLOT 3: PCM RECORD LEFT CHANNEL

Audio input frame slot 3 is the left channel output of the WM9707’s input Mux, post-ADC.

The WM9707 sends out its ADC output data (MSB first), and stuffs any trailing non-valid bit positions

with 0s to fill out its 20-bit time slot.