WM9707SCFTSLASHV datasheet(33/35 Pages) WOLFSON

33 / 35 page

WM9707

Production Data

PD Rev 4.1 June 2006

RECOMMENDED EXTERNAL COMPONENTS VALUES

COMPONENT

REFERENCE

SUGGESTED

VALUE

DESCRIPTION

C1 to C4

100nF

De-coupling for DVDD and AVDD

C5 to C17

470nF

AC coupling capacitors for setting DC level of analogue inputs to VCAP1.

Value chosen to give corner frequency below 20Hz for min 10K input impedance.

C18

µF

C19

0.1

µF

C20

µF

C21

0.1

µF

C22

µF

Reference de-coupling capacitors for ADC, DAC, Mixer and CAP2 references.

Ceramic type or similar.

C23

100nF

3D low pass filter. This value sets nominal 100Hz.

C24

47nF

3D high pass filter. This value sets nominal 1kHz.

C25 to C29

µF

Output AC coupling caps to remove VREF DC level from outputs.

C30 and C31

22pF

Optional capacitors for better crystal frequency stability.

1kΩ

See note 3 above

24.576 MHz

AC’97 master clock frequency. A bias resistor is not required, but if connected will not

affect operation if value is large (above 1M

Ω).

Table 18 External Component Values

Figure 19 Suggested SPDIF Output Circuit (DVDD = 5V)

RECOMMENDATIONS FOR 3.3V OPERATION

The device’s performance with AVDD = 3.3V is shown in Electrical Characteristics.

In 3.3V analogue operation, mid-rail reference scales to 1.65V. All ADC and DAC references are

2/3

rds of their nominal 5V value. Input and output signals that are 1Vrms in 5V applications, scale to

660mVrms in 3.3V applications. It is not possible to produce an undistorted 1Vrms output by using

the mixer PGA gain whilst running from a 3.3V analogue supply.

WM9707SCFT/V bảng dữ liệu(PDF) 33 Page - Wolfson Microelectronics plc

WM9707SCFT/V bảng dữ liệu(HTML) 33 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

bảng dữ liệu tải về

Link URL