PIC16F15213 datasheet(14/439 Pages) MICROCHIP

14 / 439 page

Guidelines for Getting Started with PIC16F152 Microcontrollers

4.1

Basic Connection Requirements

Getting started with the PIC16F152 family of 8-bit microcontrollers requires attention to a minimal set of device pin

connections before proceeding with development.

The following pins must always be connected:

• All VDD and VSS pins (see 4.2. Power Supply Pins)

• MCLR pin (see 4.3. Master Clear (MCLR) Pin)

These pins must also be connected if they are being used in the end application:

• PGC/PGD pins used for In-Circuit Serial Programming

™ (ICSP™) and debugging purposes (see 4.4. In-Circuit

Serial Programming (ICSP) Pins)

• CLKIN pin when an external clock source is used.

Additionally, the following may be required:

• VREF+/VREF- pins are used when external voltage reference for analog modules is implemented

The minimum recommended connections are shown in the figure below.

Figure 4-1. Minimum Recommended Connections

Filename:

Recommended Minimum Connections.vsdx

Title:

Last Edit:

1/2/2020

First Used:

Notes:

Rev. Rec ommende

1/2/2020

VDD

PIC MCU

MCLR

Vss

Key (all values are recommendations):

C1: 10 nF, 16V ceramic

C2: 0.1

F, 16V ceramic

R1: 10 k

R2: 100

Ω to 470Ω

4.2

Power Supply Pins

4.2.1

Decoupling Capacitors

The use of decoupling capacitors on every pair of power supply pins (VDD and VSS) is required.

Consider the following criteria when using decoupling capacitors:

• Value and type of capacitor: A 0.1 μF (100 nF), 10-25V capacitor is recommended. The capacitor may be

a low-ESR device, with a resonance frequency in the range of 200 MHz and higher. Ceramic capacitors are

recommended.

• Placement on the printed circuit board: The decoupling capacitors may be placed as close to the pins as

possible. It is recommended to place the capacitors on the same side of the board as the device. If space is

constricted, the capacitor can be placed on another layer on the PCB using a via; however, ensure that the trace

length from the pin to the capacitor is no greater than 0.25 inch (6 mm).

PIC16F15213/14/23/24/43/44

Guidelines for Getting Started with PIC16F152 Micr...

and its subsidiaries

Data Sheet

DS40002195E-page 14

PIC16F15213 bảng dữ liệu(PDF) 14 Page - Microchip Technology

PIC16F15213 bảng dữ liệu(HTML) 14 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL