CS47L24 datasheet(2/256 Pages) CIRRUS

2 / 256 page

CS47L24

Rev 4.1

Description

The CS47L24 is a highly integrated, low-power audio hub for wearable technology and other portable audio devices. It

combines an advanced DSP feature set with a flexible, high-performance audio hub codec.

The CS47L24 digital core combines a dual-core, 300MMAC DSP system, with a variety of power-efficient fixed-function

audio-processing blocks. These are supported by a fully flexible, all-digital mixing and routing engine with sample rate

converters for wide use-case flexibility. The programmable DSP cores support a range of advanced audio processing

features, including multimic noise suppression, acoustic-echo cancellation (AEC), and voice recognition functions. The

Enhanced DRE (eDRE) software is included with the CS47L24; additional software packages can be chosen according

to the requirements of the target application.

Three digital audio interfaces are provided, each supporting a wide range of standard audio sample rates and serial

interface formats. Automatic sample-rate detection enables seamless wideband/narrowband voice-call handover.

The headphone/line output driver provides stereo ground-referenced or mono BTL output. 121dB SNR, and noise levels

as low as 0.8

μVRMS, offer hi-fi quality line or headphone output. A mono Class D output driver is incorporated;

supporting up to 2-W audio output. A signal generator for controlling haptics devices is included; vibe actuators can

connect directly to the Class D speaker output or via an external driver connected to a GPIO output. All inputs, outputs,

and system interfaces can function concurrently.

The CS47L24 supports up to four digital microphone inputs. Microphone activity detection with interrupt is available.

The CS47L24 power, clocking and output driver architectures are all designed to maximize battery life in voice, music,

and standby modes. The CS47L24 is powered from 1.8- and 1.2-V external supplies. Separate MICVDD input can be

supported, for microphone operation above 1.8 V. An additional supply is required for the Class D speaker drivers

(typically direct connection to 4.2-V battery).

Two integrated FLLs provide support for a wide range of system clock frequencies. The CS47L24 is configured using an

SPI

™ control interface. The fully CS47L24 differential internal analog architecture, minimal analog signal paths, and on-

chip RF noise filters ensure a very high degree of noise immunity.

CS47L24 bảng dữ liệu(PDF) 2 Page - Cirrus Logic