MMPF0200 datasheet(16/114 Pages) NXP

16 / 114 page

NXP Semiconductors

PF0200

GENERAL DESCRIPTION

5.3.2.1

Interface signals

PWRON

PWRON is an input signal to the IC that generates a turn-on event. It can be configured to detect a level, or an edge using the

PWRON_CFG bit. Refer to section Turn on events for more details.

STANDBY

STANDBY is an input signal to the IC. When it is asserted the part enters standby mode and when de-asserted, the part exits standby

mode. STANDBY can be configured as active high or active low using the STANDBYINV bit. Refer to the section Standby mode for more

details.

Note: When operating the PMIC at VIN

≤ 2.85 V and VSNVS is programmed for a 3.0 V output, a coin cell must be present to provide

VSNVS, or the PMIC will not reliably enter and exit the STANDBY mode.

RESETBMCU

RESETBMCU is an open-drain, active low output configurable for two modes of operation. In its default mode, it is de-asserted 2.0 to

4.0 ms after the last regulator in the start-up sequence is enabled; refer to Figure 6 as an example. In this mode, the signal can be used

to bring the processor out of reset, or as an indicator that all supplies have been enabled; it is only asserted for a turn-off event.

When configured for its fault mode, RESETBMCU is de-asserted after the start-up sequence is completed only if no faults occurred during

start-up. At anytime, if a fault occurs and persists for 1.8 ms typically, RESETBMCU is asserted, LOW. The PF0200 is turned off if the

fault persists for more than 100 ms typically. The PWRON signal restarts the part, though if the fault persists, the sequence described

above will be repeated. To enter the fault mode, set bit OTP_PG_EN of register OTP PWRGD EN to “1”. This register, 0xE8, is located

on Extended page 1 of the register map. To test the fault mode, the bit may be set during TBB prototyping, or the mode may be

permanently chosen by programming OTP fuses.

SDWNB

SDWNB is an open-drain, active low output that notifies the processor of an imminent PMIC shutdown. It is asserted low for one 32 kHz

clock cycle before powering down and is then de-asserted in the OFF state.

INTB

INTB is an open-drain, active low output. It is asserted when any fault occurs, provided that the fault interrupt is unmasked. INTB is de-

asserted after the fault interrupt is cleared by software, which requires writing a “1” to the fault interrupt bit.

MMPF0200 bảng dữ liệu(PDF) 16 Page - NXP Semiconductors