TMS320DM6431 datasheet(119/227 Pages) TI1

119 / 227 page

Peripheral Information and Electrical Specifications

6.1 Parameter Information

Transmission Line

4.0 pF

1.85 pF

Z0 = 50

Ω

(see Note)

Tester Pin Electronics

Data Sheet Timing Reference Point

Output

Under

Test

NOTE: The data sheet provides timing at the device pin. For output timing analysis, the tester pin electronics and its transmission line effects must

be taken into account. A transmission line with a delay of 2 ns can be used to produce the desired transmission line effect. The transmission

line is intended as a load only. It is not necessary to add or subtract the transmission line delay (2 ns) from the data sheet timings.

Input requirements in this data sheet are tested with an input slew rate of < 4 Volts per nanosecond (4 V/ns) at the device pin.

Ω

3.5 nH

Device Pin

(see Note)

6.1.1

3.3-V Signal Transition Levels

ref

Vref = VIL MAX (or VOL MAX)

Vref = VIH MIN (or VOH MIN)

6.1.2

3.3-V Signal Transition Rates

6.1.3

Timing Parameters and Board Routing Analysis

TMS320DM6431

Digital Media Processor

www.ti.com

SPRS342C – NOVEMBER 2006 – REVISED JUNE 2008

Figure 6-1. Test Load Circuit for AC Timing Measurements

The load capacitance value stated is only for characterization and measurement of AC timing signals. This

load capacitance value does not indicate the maximum load the device is capable of driving.

All input and output timing parameters are referenced to Vref for both "0" and "1" logic levels. For 3.3 V I/O,

Vref = 1.5 V. For 1.8 V I/O, Vref = 0.9 V.

Figure 6-2. Input and Output Voltage Reference Levels for AC Timing Measurements

All rise and fall transition timing parameters are referenced to VIL MAX and VIH MIN for input clocks,

VOLMAX and VOH MIN for output clocks.

Figure 6-3. Rise and Fall Transition Time Voltage Reference Levels

All timings are tested with an input edge rate of 4 volts per nanosecond (4 V/ns).

The timing parameter values specified in this data sheet do not include delays by board routings. As a

good board design practice, such delays must always be taken into account. Timing values may be

adjusted by increasing/decreasing such delays.

Submit Documentation Feedback

Peripheral Information and Electrical Specifications

119

TMS320DM6431 bảng dữ liệu(PDF) 119 Page - Texas Instruments

TMS320DM6431 bảng dữ liệu(HTML) 119 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL