LAN9115 datasheet(29/114 Pages) MICROCHIP

29 / 114 page

 2005-2016 Microchip Technology Inc.

DS00002269A-page 29

LAN9115

WRAL (Write All): If erase/write operations are enabled in the EEPROM, this command will cause the contents of the

E2P_DATA register to be written to every EEPROM memory location. The EPC_TO bit is set if the EEPROM does not

respond within 30ms.

Table 3-8, "Required EECLK Cycles", shown below, shows the number of EECLK cycles required for each EEPROM

operation.

3.9.2.2

MAC Address Reload

The MAC address can be reloaded from the EEPROM via a host command to the E2P_CMD register. If a value of 0xA5h

is not found in the first address of the EEPROM, the EEPROM is assumed to be un-programmed and MAC Address

Reload operation will fail. The “MAC Address Loaded” bit indicates a successful load of the MAC address. The EPC_-

LOAD bit is set after a successful reload of the MAC address.

3.9.2.3

EEPROM Command and Data Registers

Refer to Section 5.3.23, "E2P_CMD – EEPROM Command Register," on page 77 and Section 5.3.24, "E2P_DATA –

EEPROM Data Register," on page 79 for a detailed description of these registers. Supported EEPROM operations are

described in these sections.

3.9.2.4

EEPROM Timing

Refer to Section 6.9, "EEPROM Timing," on page 104 for detailed EEPROM timing specifications.

FIGURE 3-10:

EEPROM WRAL CYCLE

TABLE 3-8:

REQUIRED EECLK CYCLES

Operation

Required EECLK Cycles

ERASE

ERAL

EWDS

EWEN

READ

WRITE

WRAL

EECLK

EEDIO (INPUT)

EEDIO (OUTPUT)

EECS

CSL

LAN9115 bảng dữ liệu(PDF) 29 Page - Microchip Technology