TMS320C6472ECTZ datasheet(145/269 Pages) TI1

145 / 269 page

TMS320C6472

www.ti.com

SPRS612G

– JUNE 2009 – REVISED JULY 2011

7.7.8

Reset Electrical Data/Timing

NOTE

If a configuration pin must be routed out from the device, the internal pullup/pulldown

(IPU/IPD) resistor should not be relied upon; TI recommends the use of an external

pullup/pulldown resistor.

For Figure 7-9, note the following:

•

Low group pins consist of all 3.3-V I/O/Z and O/Z pins that have active internal pull-down (IPD)

resistors. These pins become low as soon as the DVDD33 power supply has reached normal operating

conditions. (These pins are high impedance prior to DVDD33 reaching a valid level.) These pins remain

low until configured otherwise by their respective peripheral. For a list of pins containing IPD resistors,

see Table 2-5, Terminal Functions.

•

High group pins consist of all 3.3-V I/O/Z and O/Z pins that have active internal pull-up (IPU) resistors.

These pins become high as soon as the DVDD33 power supply has reached normal operating

conditions. (These pins are high impedance prior to DVDD33 reaching a valid level.) These pins remain

high until configured otherwise by their respective peripheral. For a list of pins containing IPU resistors,

see Table 2-5, Terminal Functions.

•

Z group pins consist of all I/O/Z and O/Z pins associated with I2C, RGMII, DDR2 and RapidIO, as well

as 3.3-V pins that have IPU/IPD functionality disabled by one of the six multiplexed GPIO pins. These

pins are high impedance prior to power supply ramp and remain that way when their respective power

supply has reached normal operating conditions. These pins remain in high impedance until configured

otherwise by their respective peripheral.

•

Each peripheral must be enabled through software to use it following a Power-on Reset; for more

details, see Section 7.7.1, Power-on Reset, of this document.

•

For power-supply sequence requirements, see Section 7.3.1, Power-Supply Sequencing.

C64x+ Peripheral Information and Electrical Specifications

145

Submit Documentation Feedback

Product Folder Link(s) :TMS320C6472

TMS320C6472ECTZ bảng dữ liệu(PDF) 145 Page - Texas Instruments