ZL6105

34

Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted

in the quality certifications found at www.intersil.com/en/support/qualandreliability.html

Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time

without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be

accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third

parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.

For information regarding Intersil Corporation and its products, see www.intersil.com

FN6906.5

December 19, 2013

For additional products, see www.intersil.com/en/products.html

About Intersil

Intersil Corporation is a leader in the design and manufacture of high-performance analog, mixed-signal and power management

semiconductors. The company's products address some of the largest markets within the industrial and infrastructure, personal

computing and high-end consumer markets. For more information about Intersil, visit our website at www.intersil.com.

For the most updated datasheet, application notes, related documentation and related parts, please see the respective product

information page found at www.intersil.com. You may report errors or suggestions for improving this datasheet by visiting

www.intersil.com/en/support/ask-an-expert.html. Reliability reports are also available from our website at

http://www.intersil.com/en/support/qualandreliability.html#reliability

August 5, 2010

FN6906.1

(Cont.)

On page 1, 1st sentence, changed "The ZL6105 is a digital DC/DC controller …" to "The ZL6105 is a digital power

controller …"

On page 1, 2nd paragraph, end of 1st sentence, changed from "… 3.3V to a supply operating from a 12V input."

to "… 3.3V to a multiphase current sharing supply operating from a 12V input."

On page 3, Figure 3, added arrow head to line going into pin 34 (PH_EN)

On page 3, Note 3, 3rd sentence, corrected the ohm symbol after 10k,which was missing.

On page 6, Note 1, corrected "pindependents" to "pin dependents"

On page 8, “VTRK Tracking Ramp Accuracy”, in the conditions column, added "no prebias"

On page 9, Typ entry in table for “Current Limit Protection Delay” (condition factory default): changed from 5 to 10

On page 9, Note 15 at bottom of table, 3rd sentence, corrected from "Current Share Reference must be 10ms

…", to "Current Share Reference delay must be 10ms …"

On page 13, corrected the font size for title “SMBus Mode” (to be the same font as the title “Single Resistor Output

Voltage Setting Mode”)

On page 14, 1st column, 2nd paragraph, “Soft-Start Delay and Ramp Times”, removed last two sentences,

"Precise ramp delay timing … AN2033 for details."

August 4, 2010

On page 30, 2nd column, 3rd paragraph, changed from "Up to eight (8) devices can be configured in a given

current sharing rail." to "When Auto Compensation is enabled, only two (2) devices can be configured for current

sharing. With Auto Compensation disabled, up to eight (8) devices can be configured in a given current sharing

rail."

May 17, 2010

FN6906.0 Initial Release

Revision History

The revision history provided is for informational purposes only and is believed to be accurate, but not warranted. Please go to web to make sure you

have the latest Rev. (Continued)

DATE

REVISION

CHANGE