HDM8513 datasheet(57/67 Pages) HYNIX

57 / 67 page

FEC Lock

Bit 0. Viterbi Node Sync

When this bit is set to one, the Viterbi decoder has successfully

established node synchronization.

Bit 1. Frame Sync

When this bit is set to one, the FEC chip has successfully established

word sync and frame sync.

Bit 2. Viterbi Byte Sync

When this bit is set to one, the Viterbi decoder has successfully

established byte-synchronization.

Bit 3. Pi Ambiguity

When this bit is set to one, the Viterbi decoder has successfully

resolved pi ambiguity in the input data. (i.e inverted data)

Bit 4. Pi/2 Ambiguity

When this bit is set to one, the Viterbi decoder has successfully

resolved pi/2 ambiguity in the input data

1C,1D

Accumulated Reed Solomon Errors

These two registers present a count of corrected errors since it was last

reset. Bit 7 of address 1C is the MSB and bit 0 of address 1D is the

LSB. These registers are reset by writing value to address 10H.

Accumulated Reed Solomon Data

This register presents a count of the uncorrected code words since it

was last reset. When it reaches its maximum count(255), it rolls back

to zero

and starts counting again. This register is reset by writing value to

address 10H.

Device Identifier

This register present device identifier. The current value of this register

93H

HDM8513 bảng dữ liệu(PDF) 57 Page - Hynix Semiconductor