STM32F050C4 datasheet(38/97 Pages) STMICROELECTRONICS

tên linh kiện	STM32F050C4

Giải thích chi tiết về linh kiện	Low- and medium-density advanced ARM-based 32-bit MCU with up to 32 Kbytes Flash, timers, ADC and comm. interfaces

PDF	97 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

38 / 97 page

Electrical characteristics

STM32F050xx

38/97

Doc ID 023683 Rev 1

This current consumption must be correctly distributed over all I/Os and control pins. The total output current must not be

sunk/sourced between two consecutive power supply pins referring to high pin count QFP packages.

Positive injection is not possible on these I/Os and does not occur for input voltages lower than the specified maximum

value.

A positive injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. IINJ(PIN) must never be

exceeded. Refer to Table 12: Voltage characteristics for the maximum allowed input voltage values.

A positive injection is induced by VIN>VDDA while a negative injection is induced by VIN<VSS. IINJ(PIN) must never be

exceeded. Refer also to Table 12: Voltage characteristics for the maximum allowed input voltage values. Negative injection

disturbs the analog performance of the device. See note (2) below Table 51: ADC accuracy.

When several inputs are submitted to a current injection, the maximum

ΣIINJ(PIN) is the absolute sum of the positive and

negative injected currents (instantaneous values).

Table 14.

Thermal characteristics

Symbol

Ratings

Value

Unit

TSTG

Storage temperature range

–65 to +150

°C

Maximum junction temperature

150

°C

STM32F050C4 bảng dữ liệu(PDF) 38 Page - STMicroelectronics