ST10F276E datasheet(192/235 Pages) STMICROELECTRONICS

192 / 235 page

Electrical characteristics

ST10F276E

192/235

Doc ID 12303 Rev 3

Figure 47.

A/D converter input pins scheme

Input leakage and external circuit

The series resistor utilized to limit the current to a pin (see RL in Figure 47), in combination

with a large source impedance, can lead to a degradation of A/D converter accuracy when

input leakage is present.

Data about maximum input leakage current at each pin is provided in Section 23: Electrical

characteristics. Input leakage is greatest at high operating temperatures and in general

decreases by one half for each 10°C decrease in temperature.

Considering that, for a 10-bit A/D converter one count is about 5mV (assuming VAREF = 5V),

an input leakage of 100nA acting though an RL = 50kΩ of external resistance leads to an

error of exactly one count (5mV); if the resistance were 100k

Ω, the error would become two

counts.

Eventual additional leakage due to external clamping diodes must also be taken into

account in computing the total leakage affecting the A/D converter measurements. Another

contribution to the total leakage is represented by the charge sharing effects with the sam-

pling capacitance: CS being substantially a switched capacitance, with a frequency equal to

the conversion rate of a single channel (maximum when fixed channel continuous conver-

sion mode is selected), it can be seen as a resistive path to ground. For instance, assuming

a conversion rate of 250 kHz, with CS equal to 4pF, a resistance of 1MΩ is obtained (REQ =

1 / fCCS, where fC represents the conversion rate at the considered channel). To minimize

the error induced by the voltage partitioning between this resistance (sampled voltage on

CS) and the sum of RS + RF + RL + RSW + RAD, the external circuit must be designed to

respect the following relation:

------------------------------------------------------------------------------

⋅

--- LSB

ST10F276E bảng dữ liệu(PDF) 192 Page - STMicroelectronics