ST10F276E datasheet(68/235 Pages) STMICROELECTRONICS

68 / 235 page

Bootstrap loader

ST10F276E

68/235

Doc ID 12303 Rev 3

Even if the internal IFLASH is enabled, a code cannot be executed from it.

As the XFlash is needed, XPERCON register is configured by the ABM loader code and bit

XPEN of SYSCON is set. However, as long as the EINIT instruction is not executed (and it is

not in the bootstrap loader code), the settings can be modified. To do this, perform the

following steps:

Copy in DPRAM a function that will

disable the XPeripherals by clearing XPEN in SYSCON register,

enable the needed XPeripherals by writing the correct value in XPERCON

set XPEN bit in SYSCON,

return to calling address.

Call the function from XFlash

The changing of the XPERCON value cannot be executed from the XFlash because the

XFlash is disabled by the clearing of XPEN bit in SYSCON.

5.6.5

Watchdog

As for standard boot, the Watchdog timer remains disabled during Alternate Boot Mode. In

case a Watchdog reset occurs, a software reset is generated.

Note:

See note from Section 5.2.7 concerning software reset.

5.6.6

Exiting alternate boot mode

Once the ABM mode is entered, it can be exited only with a software or hardware reset.

Note:

See note from Section 5.2.7 concerning software reset.

5.6.7

Alternate boot user software

If the rules described previously are respected (that is, mapping of variables, disabling of

interrupts, exit conditions, predefined vectors in Block 0 of Bank 2, Watchdog usage), then

users can write the software they want to execute in this mode starting from 09’0000h.

5.6.8

User/alternate mode signature integrity check

The behavior of the Alternate Boot Mode is based on the computing of a signature between

the content of two memory locations and a comparison with a reference signature. This

requires that users who use Alternate Boot have reserved and programmed the Flash

memory locations according to:

User mode signature

00'0000h: memory address of operand0 for the signature computing

00’1FFCh: memory address of operand1 for the signature computing

00’1FFEh: memory address for the signature reference

Alternate mode signature

09'0000h: memory address of operand0 for the signature computing

09’1FFCh: memory address of operand1 for the signature computing

09’1FFEh: memory address for the signature reference

ST10F276E bảng dữ liệu(PDF) 68 Page - STMicroelectronics

ST10F276E bảng dữ liệu(HTML) 68 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL