CS5467 datasheet(25/46 Pages) CIRRUS

25 / 46 page

CS5467

DS714F3

7.6 Commands

All commands are 1 byte (8 bits) long. Many command values are unused and should NOT be written by the

application program. All commands except register reads, register writes, or synchronizing commands will

abort any conversion, calibration, or any initialization sequence currently executing. This includes reset. No

commands other than reads or synchronizing should be executed until the reset sequence completes.

7.6.1 Conversion

Executes a conversion (measurement) program.

Continuous/Single Conversion

0 = Perform a Single Conversion (0xE0)

1 = Perform Continuous Conversion (0xE8)

7.6.2 Synchronization (SYNC0 and SYNC1)

The serial interface is bidirectional. While reading data on the SDO output, the SDI input must be receiving

commands. If no command is needed during a read, SYNC0 or SYNC1 commands can be sent while read

data is received on SDO.

The serial port is normally initialized by de-asserting CS. An alternative method of initialization is to send 3 or

more SYNC1 commands followed by a SYNC0. This is useful in systems where CS is not used and tied low.

7.6.3 Power Control (Stand-by, Sleep, Wake-up/Halt and Software Reset)

The CS5467 has two power-down states, stand-by and sleep. In stand-by, all circuitry except the voltage ref-

erence and clocks are turned off. In sleep mode, all circuitry except the command decoder is turned off. A

Wake-up/Halt command restores full-power operation after stand-by and issues a hardware reset after sleep.

The Software Reset command is a program that emulates a pin reset and is not a power control function.

S[1:0]

00 = Software Reset

01 = Sleep

10 = Wake-up/Halt

11 = Stand-by

1110

000

1111111

SYNC

0000

CS5467 bảng dữ liệu(PDF) 25 Page - Cirrus Logic