56F8167 datasheet(10/182 Pages) FREESCALE

10 / 182 page

56F8367 Technical Data, Rev. 9

Freescale Semiconductor

Preliminary

1.4 Architecture Block Diagram

Note: Features in italics are NOT available in the 56F8167 device and are shaded in the following figures.

The 56F8367/56F8167 architecture is shown in Figure 1-1 and Figure 1-2. Figure 1-1 illustrates how the

56800E system buses communicate with internal memories, the external memory interface and the IPBus

Bridge. Table 1-2 lists the internal buses in the 56800E architecture and provides a brief description of

their function. Figure 1-2 shows the peripherals and control blocks connected to the IPBus Bridge. The

figures do not show the on-board regulator and power and ground signals. They also do not show the

multiplexing between peripherals or the dedicated GPIOs. Please see Part 2, Signal/Connection

Descriptions, to see which signals are multiplexed with those of other peripherals.

Also shown in Figure 1-2 are connections between the PWM, Timer C and ADC blocks. These

connections allow the PWM and/or Timer C to control the timing of the start of ADC conversions. The

Timer C channel indicated can generate periodic start (SYNC) signals to the ADC to start its conversions.

In another operating mode, the PWM load interrupt (SYNC output) signal is routed internally to the Timer

C input channel as indicated. The timer can then be used to introduce a controllable delay before

generating its output signal. The timer output then triggers the ADC. To fully understand this interaction,

please see the 56F8300 Peripheral User Manual for clarification on the operation of all three of these

peripherals.

56F8167 bảng dữ liệu(PDF) 10 Page - Freescale Semiconductor, Inc