| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/20223 bảng dữ liệu(PDF) 89 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/20223 bảng dữ liệu(HTML) 89 Page - Renesas Technology Corp |
|
89 / 992 page ![]() Section 3 Exception Handling Rev. 1.00 Oct. 03, 2008 Page 63 of 962 REJ09B0465-0100 Section 3 Exception Handling 3.1 Exception Handling Types and Priority As table 3.1 indicates, exception handling is caused by a reset, trace, NMI interrupt, trap instruction, or interrupt. Exception handling is prioritized as shown in table 3.1. If two or more exceptions occur simultaneously, they are accepted and processed in order of priority. Exception sources, the stack structure, and operation of the CPU vary depending on the interrupt control mode. For details on the interrupt control mode, see section 4, Interrupt Controller. Table 3.1 Exception Handling Types and Priority Priority Exception Type Start Timing of Exception Handling High Reset Started immediately after a low-to-high transition at the RES pin, or by other reset sources. The CPU enters the reset state when the RES pin is low. Trace* 1 Started when execution of the current instruction or exception handling ends, if the trace (T) bit in EXR is set to 1. NMI Generated when an edge of the NMI pin is input. An NMI interrupt request has the highest priority among interrupt requests. It is always accepted regardless of the value of the I bit in CCR. Trap instruction* 3 Started by execution of a trap instruction (TRAPA). Low Interrupt Started when execution of the current instruction or exception handling ends, if an interrupt request has been issued.* 2 Notes: 1. Traces are enabled only in interrupt control mode 2. Trace exception handling is not executed after execution of an RTE instruction. 2. Interrupt detection is not performed on completion of ANDC, ORC, XORC, or LDC instruction execution, or on completion of reset exception handling. 3. Trap instruction exception handling requests are accepted at all times in program execution state. 3.2 Exception Handling Sources and Vector Table Different vector addresses are assigned to different exception sources. For details on the exception sources and their vector addresses, see section 4, Interrupt Controller. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |