C167CS datasheet(104/517 Pages) INFINEON

104 / 517 page

C167CS

Derivatives

Interrupt and Trap Functions

User’s Manual

5-21

V2.0, 2000-07

• When internal hold conditions between instruction pairs N – 2/N – 1 or N – 1/N occur,

or instruction N explicitly writes to the PSW or the SP, the minimum interrupt response

time may be extended by 1 state time for each of these conditions.

• When instruction N reads an operand from the internal code memory, or when N is a

call, return, trap, or MOV Rn, [Rm+ #data16] instruction, the minimum interrupt

response time may additionally be extended by 2 state times during internal code

memory program execution.

• In case instruction N reads the PSW and instruction N – 1 has an effect on the

condition flags, the interrupt response time may additionally be extended by 2 state

times.

The worst case interrupt response time during internal code memory program execution

adds to 12 state times (24 TCL).

Any reference to external locations increases the interrupt response time due to pipeline

related access priorities. The following conditions have to be considered:

• Instruction fetch from an external location

• Operand read from an external location

• Result write-back to an external location

Depending on where the instructions, source and destination operands are located,

there are a number of combinations. Note, however, that only access conflicts contribute

to the delay.

A few examples illustrate these delays:

• The worst case interrupt response time including external accesses will occur, when

instructions N, N + 1 and N + 2 are executed out of external memory, instructions N – 1

and N require external operand read accesses, instructions N – 3 through N write

back external operands, and the interrupt vector also points to an external location. In

this case the interrupt response time is the time to perform 9 word bus accesses,

because instruction I1 cannot be fetched via the external bus until all write, fetch and

read requests of preceding instructions in the pipeline are terminated.

• When the above example has the interrupt vector pointing into the internal code

memory, the interrupt response time is 7 word bus accesses plus 2 states, because

fetching of instruction I1 from internal code memory can start earlier.

• When instructions N, N + 1 and N + 2 are executed out of external memory and the

interrupt vector also points to an external location, but all operands for instructions N – 3

through N are in internal memory, then the interrupt response time is the time to

perform 3 word bus accesses.

• When the above example has the interrupt vector pointing into the internal code

memory, the interrupt response time is 1 word bus access plus 4 states.

C167CS bảng dữ liệu(PDF) 104 Page - Infineon Technologies AG

C167CS bảng dữ liệu(HTML) 104 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL