STA333W datasheet(23/50 Pages) STMICROELECTRONICS

23 / 50 page

DocID13365 Rev 3

23/50

STA333W

Interpolation ratio select

The STA333W has variable interpolation (oversampling) settings such that internal

processing and DDX output rates remain consistent. The first processing block interpolates

by either 2 times or 1 time (pass-through) or provides a 2-times downsample. The

oversampling ratio of this interpolation is determined by the IR bits.

Thermal warning recovery bypass

If the thermal warning adjustment is enabled (TWAB = 0), then the thermal warning recovery

determines if the -3 dB output limit is removed when thermal warning is negative.

If TWRB = 0 and TWAB = 0, then when a thermal warning disappears the -3 dB output limit

is removed and the gain is added back to the system. If TWRB = 1 and TWAB = 0, then

when a thermal warning disappears the -3 dB output limit remains until TWRB is changed to

zero or the device is reset.

Table 11. Interpolation ratio select

Bit

R/W

RST

Name

Description

4:3

R/W

IR [1:0]

Interpolation ratio select: Selects internal

interpolation ratio based on input I²SI²S sample

frequency.

Table 12. IR bit settings as a function of input sample rate

Input sample rate fS (kHz)

1st stage interpolation ratio

2-times oversampling

44.1

2-times oversampling

88.2

Pass-through

176.2

2-times downsampling

192

2-times downsampling

Table 13. Thermal warning recovery

Bit

R/W

RST

Name

Description

5R/W

1TWRB

Thermal warning recovery bypass:

0: thermal warning recovery enabled

1: thermal warning recovery disabled

STA333W bảng dữ liệu(PDF) 23 Page - STMicroelectronics

STA333W bảng dữ liệu(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

bảng dữ liệu tải về

Link URL