DSP56F802 datasheet(35/40 Pages) FREESCALE

35 / 40 page

Electrical Design Considerations

56F802 Technical Data, Rev. 9

Freescale Semiconductor

•

Measure the thermal resistance from the junction to where the leads are attached to the case. This definition

is approximately equal to a junction to board thermal resistance.

•

Use the value obtained by the equation (TJ – TT)/PD where TT is the temperature of the package case

determined by a thermocouple.

The thermal characterization parameter is measured per JESD51-2 specification using a 40-gauge type T

thermocouple epoxied to the top center of the package case. The thermocouple should be positioned so

that the thermocouple junction rests on the package. A small amount of epoxy is placed over the

thermocouple junction and over about 1mm of wire extending from the junction. The thermocouple wire

is placed flat against the package case to avoid measurement errors caused by cooling effects of the

thermocouple wire.

When heat sink is used, the junction temperature is determined from a thermocouple inserted at the

interface between the case of the package and the interface material. A clearance slot or hole is normally

required in the heat sink. Minimizing the size of the clearance is important to minimize the change in

thermal performance caused by removing part of the thermal interface to the heat sink. Because of the

experimental difficulties with this technique, many engineers measure the heat sink temperature and then

back-calculate the case temperature using a separate measurement of the thermal resistance of the

interface. From this case temperature, the junction temperature is determined from the junction-to-case

thermal resistance.

5.2 Electrical Design Considerations

Use the following list of considerations to assure correct operation:

•

Provide a low-impedance path from the board power supply to each VDD pin on the controller, and from the

board ground to each VSS (GND) pin.

•

The minimum bypass requirement is to place 0.1

μF capacitors positioned as close as possible to the

package supply pins. The recommended bypass configuration is to place one bypass capacitor on each of

the VDD/VSS pairs, including VDDA/VSSA. Ceramic and tantalum capacitors tend to provide better

performance tolerances.

CAUTION

This device contains protective circuitry to guard against

damage due to high static voltage or electrical fields.

However, normal precautions are advised to avoid

application of any voltages higher than maximum rated

voltages to this high-impedance circuit. Reliability of

operation is enhanced if unused inputs are tied to an

appropriate voltage level.

DSP56F802 bảng dữ liệu(PDF) 35 Page - Freescale Semiconductor, Inc

DSP56F802 bảng dữ liệu(HTML) 35 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

bảng dữ liệu tải về

Link URL