LAN9218 datasheet(18/130 Pages) SMSC

18 / 130 page

High-Performance Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX

Datasheet

Revision 1.5 (07-18-06)

SMSC LAN9218

DATASHEET

Wakeup Indicator

PME

O8/OD8

When programmed to do so, is

asserted when the LAN9218 detects

a wake event and is requesting the

system to wake up from the

associated sleep state. The polarity

and buffer type of this signal is

programmable.

Note:

Detection of a Power

Management Event, and

assertion of the PME signal

will not wakeup the

LAN9218. The LAN9218 will

only wake up when it

detects a host write cycle

(assertion of nCS and

nWR). Although any write to

the LAN9218, regardless of

the data written, will wake-

up the device when it is in a

power-saving mode, it is

required that the

BYTE_TEST register be

used for this purpose.

100,99

,98

General Purpose

I/O data,

nLED1 (Speed

Indicator),

nLED2 (Link &

Activity Indicator),

nLED3 (Full-

Duplex

Indicator).

GPIO[2:0]/

LED[3:1]

IS/O12/

OD12

General Purpose I/O data: These

three general-purpose signals are

fully programmable as either push-

pull output, open-drain output or input

by writing the GPIO_CFG

configuration register in the CSR’s.

They are also multiplexed as GP LED

connections.

GPIO signals are Schmitt-triggered

inputs. When configured as LED

outputs these signals are open-drain.

nLED1 (Speed Indicator). This

signal is driven low when the

operating speed is 100Mbs, during

auto-negotiation and when the cable

is disconnected. This signal is driven

high only during 10Mbs operation.

nLED2 (Link & Activity Indicator).

This signal is driven low (LED on)

when the LAN9218 detects a valid

link. This signal is pulsed high (LED

off) for 80mS whenever transmit or

receive activity is detected. This

signal is then driven low again for a

minimum of 80mS, after which time it

will repeat the process if TX or RX

activity is detected. Effectively, LED2

is activated solid for a link. When

transmit or receive activity is sensed

LED2 will flash as an activity

indicator.

nLED3 (Full-Duplex Indicator). This

signal is driven low when the link is

operating in full-duplex mode.

Table 2.5 System and Power Signals (continued)

NO.

NAME

SYMBOL

BUFFER

TYPE

NUM

PINS

DESCRIPTION

LAN9218 bảng dữ liệu(PDF) 18 Page - SMSC Corporation

LAN9218 bảng dữ liệu(HTML) 18 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL