UPD17062 datasheet(180/298 Pages) RENESAS

180 / 298 page

178

µPD17062

14.4.1

Power-on Reset at Normal Operation

Fig. 14-5 (a) shows power-on reset at normal operation.

As shown in Fig. 14-5 (a), when the VDD drops below 3.5 V, the power-on clear signal is output and operation

of the device stops regardless of the input level of the CE pin.

When VDD then rises to 3.5 V or greater, after a 50 ms halt, the program starts from address 0000H.

Normal operation refers to the state in which the clock-stop instruction is not used. This also includes the

halt state set by the halt instruction.

14.4.2

Power-on Reset in Clock-Stop State

Fig. 14-5 (b) shows power-on reset in the clock-stop state.

As shown in Fig. 14-5 (b), when VDD drops below 2.2 V, the power-on clear signal is output and device

operation stops.

However, since the device is in the clock-stop state, its operation apparently does not change.

When VDD rises to 3.5 V or greater, after a 50 ms halt, the program starts from address 0000H.

14.4.3

Power-on Reset When VDD Rises From 0 V

Fig. 14-5 (c) shows power-on reset when VDD rises from 0 V.

As shown in Fig. 14-5 (c), the power-on clear signal is being output while VDD is rising from 0 to 3.5 V.

When VDD rises above the power-on clear voltage, the crystal oscillation circuit starts and after a 50 ms halt,

the program starts from address 0000H.

UPD17062 bảng dữ liệu(PDF) 180 Page - Renesas Technology Corp