JS28F320J3F75 datasheet(21/67 Pages) NUMONYX

21 / 67 page

Numonyx® Embedded Flash Memory (J3 65 nm) Single Bit per Cell (SBC)

Datasheet

Note:

Power supplies connected or sequenced together.

Device inputs must not be driven until all supply voltages reach their minimum range.

RP# should be low during power transitions.

5.3.2

Power Supply Decoupling

When the device is enabled, many internal conditions change. Circuits are energized,

charge pumps are switched on, and internal voltage nodes are ramped. All of this

internal activities produce transient signals. The magnitude of the transient signals

depends on the device and system loading. To minimize the effect of these transient

signals, a 0.1 µF ceramic capacitor is required across each VCC/VSS and VCCQ signal.

Capacitors should be placed as close as possible to device connections.

Additionally, for every eight flash devices, a 4.7 µF electrolytic capacitor should be

placed between VCC and VSS at the power supply connection. This 4.7 µF capacitor

should help overcome voltage slumps caused by PCB trace inductance.

5.4

Reset

By holding the flash device in reset during power-up and power-down transitions,

invalid bus conditions may be masked. The flash device enters reset mode when RP# is

driven low. In reset, internal flash circuitry is disabled and outputs are placed in a high-

impedance state. After return from reset, a certain amount of time is required before

the flash device is able to perform normal operations. After return from reset, the flash

device defaults to asynchronous page mode. If RP# is driven low during a program or

erase operation, the program or erase operation will be aborted and the memory

contents at the aborted block or address are no longer valid. See Figure 12, “AC

Waveform for Reset Operation” on page 28 for detailed information regarding reset

timings.

Table 6:

Power-Up/Down Sequence

Power Supply

Voltage

Power-Up Sequence

Power-Down Sequence

VCC(min)

1st

1st(1)

Sequencing not

required(1)

3rd

2nd

2nd(1)

Sequencing not

required(1)

VCCQ(min)

2nd

2nd(1)

2nd

1st(1)

VPEN(min)

3rd

2nd

1st

JS28F320J3F75 bảng dữ liệu(PDF) 21 Page - Numonyx B.V

JS28F320J3F75 bảng dữ liệu(HTML) 21 Page - Numonyx B.V

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

bảng dữ liệu tải về

Link URL