| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
JS28F320J3F75 bảng dữ liệu(PDF) 41 Page - Numonyx B.V |
|
|
|||||||||||||||||||||||||||||
JS28F320J3F75 bảng dữ liệu(HTML) 41 Page - Numonyx B.V |
|
41 / 67 page ![]() Numonyx® Embedded Flash Memory (J3 65 nm) Single Bit per Cell (SBC) Datasheet 40 programming operations, rendering array contents at the addressed location(s) indeterminate. To suspend an on-going erase or program operation, issue the Suspend command to any device address. The program or erase operation suspends at pre-determined points during the operation after a delay of tSUSP. Suspend is achieved whenSTS (in RY/BY# mode) goes high, SR[7,6] = 1 (erase-suspend) or SR[7,2] = 1 (program-suspend). Note: Issuing the Suspend command does not change the read mode of the device. The device will be in Read Status Register mode from when the erase or program command was first issued, unless the read mode was changed prior to issuing the Suspend command. Not all commands are allowed when the device is suspended. Table 25 shows which device commands are allowed during Program Suspend or Erase Suspend. During Suspend, array-read operations are not allowed in blocks being erased or programmed. A block-erase under program-suspend is not allowed. However, word-program under erase-suspend is allowed, and can be suspended. This results in a simultaneous erase- suspend/ program-suspend condition, indicated by SR[7,6,2] = 1. Table 24: Suspend and Resume Command Bus-Cycles Command Setup Write Cycle Confirm Write Cycle Address Bus Data Bus Address Bus Data Bus Suspend Device Address 00B0h — — Resume Device Address 00D0h — — Table 25: Valid Commands During Suspend Device Command Program Suspend Erase Suspend STS Configuration Allowed Allowed Read Array Allowed Allowed Read Status Register Allowed Allowed Clear Status Register Allowed Allowed Read Device Information Allowed Allowed CFI Query Allowed Allowed Word/Byte Program Not Allowed Allowed Buffered Program Not Allowed Allowed Block Erase Not Allowed Not Allowed Program Suspend Not Allowed Allowed Erase Suspend Not Allowed Not Allowed Program/Erase Resume Allowed Allowed Lock Block Not Allowed Not Allowed Unlock Block Not Allowed Not Allowed Program OTP Register Not Allowed Not Allowed Blank Check Not Allowed Not Allowed |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |