JS28F320J3F75 datasheet(11/67 Pages) NUMONYX

11 / 67 page

Numonyx® Embedded Flash Memory (J3 65 nm) Single Bit per Cell (SBC)

Datasheet

The Status Register indicates when the WSM’s block erase, program, or lock-bit

configuration operation completes.

The STS (status) output gives an additional indicator of WSM activity by providing both

a hardware signal of status (versus software polling) and status masking (interrupt

masking for background block erase, for example). Status indication using STS

minimizes both CPU overhead and system power consumption. When configured in

level mode (default mode), it acts as a RY/BY# signal. When low, STS indicates that the

WSM is performing a block erase, program, or lock-bit configuration. STS-high indicates

that the WSM is ready for a new command, block erase is suspended (and

programming is inactive), program is suspended, or the device is in reset/power-down

mode. Additionally, the configuration command allows the STS signal to be configured

to pulse on completion of programming and/or block erases.

Three CE signals are used to enable and disable the device. A unique CE logic design

(see Table 17, “Chip Enable Truth Table for 32-, 64-, 128-Mb” on page 30) reduces

decoder logic typically required for multi-chip designs. External logic is not required

when designing a single chip, a dual chip, or a 4-chip miniature card or SIMM module.

The BYTE# signal allows either x8 or x16 read/writes to the device:

• BYTE#-low enables 8-bit mode; address A0 selects between the low byte and high

byte.

• BYTE#-high enables16-bit operation; address A1 becomes the lowest order

address and address A0 is not used (don’t care).

Figure 1, “Memory Block Diagram for 32-, 64-, 128-Mbit” on page 11 shows a device

block diagram.

When the device is disabled (see Table 17, “Chip Enable Truth Table for 32-, 64-, 128-

Mb” on page 30), with CEx at VIH and RP# at VIH, the standby mode is enabled. When

RP# is at VIL, a further power-down mode is enabled which minimizes power

consumption and provides write protection during reset. A reset time (tPHQV) is

required from RP# going high until data outputs are valid. Likewise, the device has a

wake time (tPHWL) from RP#-high until writes to the CUI are recognized. With RP# at

VIL, the WSM is reset and the Status Register is cleared.

JS28F320J3F75 bảng dữ liệu(PDF) 11 Page - Numonyx B.V