����Warning: Configuration settings are PERMANENT. We would like to stress the fact that these cannot be

changed later. If you intend to follow along with this tutorial, then configure with SparkFun standard

settings.

If you intend to use different features of the co-processor like the Diffie-Hellman Key Exchange and some of

its other use cases, please consider designing your own custom configuration. This hookup guide only

focuses on digital signature creation and verification.

This example shows how to setup your Cryptographic Co-processor with SparkFun's standard settings. This will

allow you to sign data and verify data with external signatures. The type of private keys we use in all of these

examples are ECC. We have also included an example to use the random number generator and a challenge

example. Beyond these functions, you may need to start with a different custom configuration.

with a fresh chip is successful, your Artemis will print out some useful information about your chip.

Output in the Arduino Serial Monitor.

Example 2: Sign

watch your serial terminal at 115200 baud. Note, you may need to hit reset.