AT45DB021E datasheet(42/74 Pages) DIALOG

42 / 74 page

AT45DB021E

DS-AT45DB021E—8789J—03/2021

Software Reset

In some applications, it might be necessary to prematurely terminate a program or erase cycle early rather than

wait the hundreds of microseconds or milliseconds necessary for the program or erase operation to complete

normally. The Software Reset command allows a program or erase operation in progress to be ended abruptly and

returns the device to an idle state.

To perform a Software Reset, the CS pin must be asserted and a four-byte command sequence of F0h, 00h, 00h,

and 00h must be clocked into the device. Any additional data clocked into the device after the last byte are ignored.

When the CS pin is deasserted, the program or erase operation currently in progress is terminated within a time

tSWRST. Since the program or erase operation might not complete before the device is reset, the contents of the

page being programmed or erased cannot be guaranteed to be valid.

The Software Reset command has no effect on the states of the Sector Protection Register, the Sector Lockdown

The complete four-byte opcode must be clocked into the device before the CS pin is deasserted; otherwise, no

reset operation is performed.

Table 14-1. Software Reset

Figure 14-1. Software Reset Timing

Command

Byte 1

Byte 2

Byte 3

Byte 4

Software Reset

F0h

00h

F0h

00h

Each transition represents eight bits

AT45DB021E bảng dữ liệu(PDF) 42 Page - Dialog Semiconductor