PRT2011CVL4A datasheet(28/113 Pages) NXP

28 / 113 page

i.MX RT1064 Crossover Processors for Industrial Products, Rev. 2, 08/2020

NXP Semiconductors

Electrical Characteristics

NOTE

USB_OTG1_VBUS, USB_OTG2_VBUS, and VDDA_ADC_3P3 are not

part of the power supply sequence and may be powered at any time.

4.2.1.2

Power-down sequence

The following restrictions must be followed:

•

VDD_SNVS_IN supply must be turned off after any other power supply or be connected (shorted)

with VDD_HIGH_IN supply.

•

If a coin cell is used to power VDD_SNVS_IN, then ensure that it is removed after any other supply

is switched off.

4.2.1.3

Power supplies usage

All I/O pins should not be externally driven while the I/O power supply for the pin (NVCC_xxx) is OFF.

This can cause internal latch-up and malfunctions due to reverse current flows. For information about I/O

power supply of each pin, see “Power Rail” columns in pin list tables of Section 7, Package information

and contact assignments.”

4.2.2

Integrated LDO voltage regulator parameters

Various internal supplies can be powered ON from internal LDO voltage regulators. All the supply pins

named *_CAP must be connected to external capacitors. The on-board LDOs are intended for internal use

only and should not be used to power any external circuitry. See the i.MX RT1064 Reference Manual

(IMXRT1064RM) for details on the power tree scheme.

NOTE

The *_CAP signals should not be powered externally. These signals are

intended for internal LDO operation only.

4.2.2.1

Digital regulators (LDO_SNVS)

There are one digital LDO regulator (“Digital”, because of the logic loads that they drive, not because of

their construction). The advantages of the regulator is to reduce the input supply variation because of its

input supply ripple rejection and its on-die trimming. This translates into more stable voltage for the

on-chip logics.

The regulator has two basic modes:

•

Power Gate. The regulation FET is switched fully off limiting the current draw from the supply.

The analog part of the regulator is powered down here limiting the power consumption.

•

Analog regulation mode. The regulation FET is controlled such that the output voltage of the

regulator equals the target voltage.

For additional information, see the i.MX RT1064 Reference Manual (IMXRT1064RM).

PRT2011CVL4A bảng dữ liệu(PDF) 28 Page - NXP Semiconductors

PRT2011CVL4A bảng dữ liệu(HTML) 28 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL