ZL2103ALAF datasheet(6/28 Pages) RENESAS

6 / 28 page

ZL2103

FN6966 Rev 5.00

Page 6 of 28

May 3, 2011

Absolute Maximum Ratings

Thermal Information

DC Supply Voltage for VDDP, VDDS Pins . . . . . . . . . . . . . . . . . . -0.3V to 17V

High-Side Supply Voltage for BST Pin. . . . . . . . . . . . . . . . . . . . . -0.3V to 25V

High-Side Boost Voltage for BST - SW Pins . . . . . . . . . . . . . . . . . -0.3V to 8V

Internal MOSFET Reference for VR Pin . . . . . . . . . . . . . . . . . . -0.3V to 8.5V

Internal Analog Reference for VRA Pin . . . . . . . . . . . . . . . . . . -0.3V to 6.5V

Internal 2.5 V Reference for V2P5 Pin. . . . . . . . . . . . . . . . . . . . . -0.3V to 3V

Logic I/O Voltage for EN, CFG, DDC, FC, MGN, PG, SDA, SCL,

SA, SALRT, SS, SYNC, VTRK, VSET, VSEN Pins . . . . . . . . . . . . . . . . -0.3V to 6.5V

Ground Differential for DGND - SGND,

PGND - SGND Pins

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±0.3V

MOSFET Drive Reference Current for for VR Pin

Internal Bias Usage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20mA

Switch Node Current for SW Pin

Peak (Sink Or Source) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5A

ESD Rating

Human Body Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2kV

Machine Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500V

Latch-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Tested to JESD78

Thermal Resistance (Typical)

JA (°C/W)

JC (°C/W)

36 Ld QFN (Notes 6, 7) . . . . . . . . . . . . . . . .

Junction Temperature Range . . . . . . . . . . . . . . . . . . . . . . .-55°C to +150°C

Storage Temperature Range. . . . . . . . . . . . . . . . . . . . . . . .-55°C to +150°C

Dissipation Limits (Note 8)

TA = +25°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.5W

TA = +55°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5W

TA = +85°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.4W

Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see link below

http://www.intersil.com/pbfree/Pb-FreeReflow.asp

Recommended Operating Conditions

Input Supply Voltage Range, VDDP, VDDS (See Figure 13)

VDDS tied to VR, VRA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.5V

VDDS tied to VR, VRA Floating . . . . . . . . . . . . . . . . . . . . . . . . 5.5V to 7.5V

VR, VRA Floating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.5V to 14V

Output Voltage Range, VOUT (Note 9) . . . . . . . . . . . . . . . . . . . . 0.54V to 5.5V

Operating Junction Temperature Range, TJ . . . . . . . . . . . . .-40°C to +125°C

CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product

reliability and result in failures not covered by warranty.

NOTES:

JA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See Tech

Brief TB379.

7. For

JC, the “case temp” location is the center of the exposed metal pad on the package underside.

8. Thermal impedance depends on layout.

9. Includes margin limits.

Electrical Specifications V

DDP = VDDS = 12V, TA = -40°C to +85°C unless otherwise noted. (Note 10) Typical values are at TA = +25°C.

Boldface limits apply over the operating temperature range, -40°C to +85°C.

PARAMETER

CONDITIONS

MIN

(Note 20)

TYP

MAX

(Note 20)

UNIT

Input and Supply Characteristics

IDD Supply Current

fSW = 200kHz, no load

fSW = 1MHz, no load

IDDS Shutdown Current

EN = 0V, No I2C/SMBus activity

0.6

VR Reference Output Voltage

VDD > 8V, IVR < 10mA

6.5

7.0

7.5

VRA Reference Output Voltage

VDD > 5.5V, IVRA < 20mA

4.5

5.1

5.5

V2P5 Reference Output Voltage

IV2P5 < 20mA

2.25

2.5

2.75

Output Characteristics

Output Current

IRMS, Continuous

Output Voltage Adjustment Range (Note 11)

VIN > VOUT

0.6

5.0

Output Voltage Setpoint Resolution

Set using resistors

Set using I2C/SMBus

±0.025

% FS

(Note 12)

Vsen Output Voltage Accuracy

Includes line, load, temp

-1

Vsen Input Bias Current

VSEN = 5.5V

110

200

µA

Soft-start Delay Duration Range (Note 13)

Set using SS pin or resistor

Set using I2C/SMBus

0.002

500

ZL2103ALAF bảng dữ liệu(PDF) 6 Page - Renesas Technology Corp

ZL2103ALAF bảng dữ liệu(HTML) 6 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

bảng dữ liệu tải về

Link URL