AT40K datasheet(63/67 Pages) ATMEL

63 / 67 page

AT40K/AT40KLV Series FPGA

0896C–FPGA–04/02

208Q1 – TQFP

2325 Orchard Parkway

San Jose, CA 95131

TITLE

DRAWING NO.

REV.

208Q1

11/30/01

Side View

Bottom View

Top View

COMMON DIMENSIONS

(Unit of Measure = mm)

SYMBOL

MIN

NOM

MAX

NOTE

208Q1, 208-lead (28 x 28 mm Body, 2.6 Form Opt.),

Plastic Quad Flat Pack (PQFP)

0.25

0.50

3.20

3.40

3.60

30.60 BSC

28.00 BSC

2, 3

30.60 BSC

28.00 BSC

2, 3

0.50 BSC

0.17

0.27

1.30 REF

Notes: 1. This drawing is for general information only; refer to JEDEC Drawing MO-153, Variation AA, for proper dimensions, tolerances, datums, etc.

2. The top package body size may be smaller than the bottom package size by as much as 0.15 mm.

3. Dimensions D1 and E1 do not include mold protrusions. Allowable protrusion is 0.25 mm per side. D1 and E1 are maximum plastic

body size dimensions including mold mismatch.

4. Dimension b does not include Dambar protrusion. Allowable Dambar protrusion shall not cause the lead width to exceed the maximum b

dimension by more than 0.08 mm. Dambar cannot be located on the lower radius or the foot. Minimum space between protrusion

and an adjacent lead is 0.07 mm.

AT40K bảng dữ liệu(PDF) 63 Page - ATMEL Corporation

AT40K bảng dữ liệu(HTML) 63 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

bảng dữ liệu tải về

Link URL