AT40K datasheet(61/67 Pages) ATMEL

61 / 67 page

AT40K/AT40KLV Series FPGA

0896C–FPGA–04/02

144L1 – LQFP

2325 Orchard Parkway

San Jose, CA 95131

TITLE

DRAWING NO.

REV.

144L1

11/30/01

Bottom View

Side View

Top View

COMMON DIMENSIONS

(Unit of Measure = mm)

SYMBOL

MIN

NOM

MAX

NOTE

144L1, 144-lead (20 x 20 x 1.4 mm Body), Low Profile

Plastic Quad Flat Pack (LQFP)

1. This drawing is for general information only; refer to JEDEC Drawing MS-026 for additional information.

2. The top package body size may be smaller than the bottom package size by as much as 0.15 mm.

3. Dimensions D1 and E1 do not include mold protrusions. Allowable protrusion is 0.25 mm per side. D1 and E1 are maximum plastic

body size dimensions including mold mismatch.

4. Dimension b does not include Dambar protrusion. Allowable Dambar protrusion shall not cause the lead width to exceed the maximum

b dimension by more than 0.08 mm. Dambar cannot be located on the lower radius or the foot. Minimum space between protrusion and

an adjacent lead is 0.07 mm for 0.4 and 0.5 mm pitch packages.

5. These dimensions apply to the flat section of the lead between 0.10 mm and 0.25 mm from the lead tip.

6. A1 is defined as the distance from the seating place to the lowest point on the package body.

0.05

0.15

1.35

1.40

1.45

22.00 BSC

20.00 BSC

2, 3

22.00 BSC

20.00 BSC

2, 3

0.50 BSC

0.17

0.22

0.27

4, 5

1.00 REF

Notes:

AT40K bảng dữ liệu(PDF) 61 Page - ATMEL Corporation

AT40K bảng dữ liệu(HTML) 61 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

bảng dữ liệu tải về

Link URL