L6706 datasheet(33/47 Pages) STMICROELECTRONICS

33 / 47 page

L6706

Soft-start

Doc ID 15698 Rev 2

33/47

Note:

Connecting SSOSC pin to SGND through only the RFLIM_SS resistor (blue one network in

Figure 14), the soft-start time depends on the FLIMIT selected.

In this case use the following relationship to select FLIMIT and as a consequence the soft-

start time:

Figure 16.

Soft-start time (TSS) vs FLIMIT when using RFLIM_SS resistor versus SGND

14.1

Low-side-less startup

In order to avoid any kind of negative undershoot on the load side during startup, L6706

performs a special sequence in enabling LS driver to switch: during the soft-start phase, the

LS driver results disabled (LS = OFF) until the HS starts to switch. This avoid the dangerous

negative spike on the output voltage that can happen if starting over a pre-biased output

(see Figure 17).

This particular feature of the device masks the LS turn-on only from the control loop point of

view: protections are still allowed to turn-ON the LS MOSFET in case of over voltage if

needed.

Figure 17.

Low-side-less startup comparison.WITH LS-Less startup

FLIM

–

[]

2.11 10

⋅

LIMIT kHz

[]

---------------------------------

D2 μs

[]

5.275 10

⋅

LIMIT kHz

[]

---------------------------------

VOUT

LGATE

WITHOUT LS-Less startup

WITH LS-Less startup

L6706 bảng dữ liệu(PDF) 33 Page - STMicroelectronics

L6706 bảng dữ liệu(HTML) 33 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

bảng dữ liệu tải về

Link URL