| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
IOBUS0 bảng dữ liệu(PDF) 36 Page - Future Technology Devices International Ltd. |
|
|
|||||||||||||||||||||||||||||
IOBUS0 bảng dữ liệu(HTML) 36 Page - Future Technology Devices International Ltd. |
|
36 / 88 page ![]() 36 C opyright © Future T ec hnology Devic es I nternational Limited Datasheet Vinculum-II Embedded Dual USB Host Controller IC V ers ion 1 .7 Doc ument N o.: FT _000138 C learance N o.: FT DI# 1 43 6 Peripheral Interfaces In addition to the two USB Host and Slave blocks, VNC2 contains the following peripheral interfaces: Universal Asynchronous Receiver Transmitter (UART) Two Serial Peripheral Interface (SPI) slaves SPI Master Debugger Interface Parallel FIFO Interface (245 mode and synchronous FIFO mode) General Purpose Timers Eight Pulse Width Modulation blocks (PWM) General Purpose Input Output (GPIO) The following sections describe each peripheral in detail. 6.1 UART Interface When the data and control bus are configured in UART mode, the interface implements a standard asynchronous serial UART port with flow control, for example RS232/422/485. The UART can support baud rates from 183 baud to 6 Mbaud. The maximum UART speed is determined by the CPU speed/8.The CPU can be run at three frequencies, therefore the following maximum rates apply: CPU Frequency Maximum UART Speed 48 MHz 6 Mbaud 24 MHz 3 Mbaud 12 MHz 1.5 Mbaud Data transfer uses NRZ (Non-Return to Zero) data format consisting of 1 start bit, 7 or 8 data bits, an optional parity bit, and one or two stop bits. When transmitting the data bits, the least significant bit is transmitted first. Transmit and receive waveforms are illustrated in Figure 6.1 and Figure 6.2: Figure 6.1 UART Receive Waveform Figure 6.2 UART Transmit Waveform Baud rate (default =9600 baud), flow control settings (default = RTS/CTS), number of data bits (default=8), parity (default is no parity) and number of stop bits (default=1) are all configurable using the firmware command interface. Please refer to http://www.ftdichip.com. uart_tx_active is transmit enable, this output may be used in RS485 designs to control the transmit of the line driver. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |