MB9B110T datasheet(65/129 Pages) SPANSION

65 / 129 page

D a t a S h e e t

MB9B110T-DS706-00016-3v0-E, February 10, 2015

CONFIDENTIAL

 Serial Communication

There is a possibility to receive wrong data due to the noise or other causes on the serial communication.

Therefore, design a printed circuit board so as to avoid noise.

Consider the case of receiving wrong data due to noise, perform error detection such as by applying a

checksum of data at the end. If an error is detected, retransmit the data.

 Differences in features among the products with different memory sizes and between

Flash products and MASK products

The electric characteristics including power consumption, ESD, latch-up, noise characteristics, and

oscillation characteristics among the products with different memory sizes and between Flash products and

MASK products are different because chip layout and memory structures are different.

If you are switching to use a different product of the same series, please make sure to evaluate the electric

characteristics.

 Base Timer

In the case of using ch.8 and ch.9 at I/O mode 1 (timer full mode), the TIOA09 pin cannot be used for

external startup trigger input (TGIN).

Be sure to use the pin with making ESG1 and ESG2 bits of the Timer Control Register (Ch.9-TMCR) in the

Base Timer to be "0b00" in order to disable trigger input.

MB9B110T bảng dữ liệu(PDF) 65 Page - SPANSION