W25X05CLZPIG datasheet(10/51 Pages) WINBOND

10 / 51 page

W25X05CL/10CL/20CL

Publication Release Date: March 23, 2012

- 10 -

Revision B

CONTROL AND STATUS REGISTERS

The Read Status Register instruction can be used to provide status on the availability of the Flash

memory array, if the device is write enabled or disabled, and the state of write protection. The Write

Status Register instruction can be used to configure the device write protection features.

8.1

STATUS REGISTER

8.1.1 BUSY

BUSY is a read only bit in the status register (S0) that is set to a 1 state when the device is executing

a Page Program, Sector Erase, Block Erase, Chip Erase or Write Status Register instruction. During

this time the device will ignore further instructions except for the Read Status Register instruction (see

tW, tPP, tSE, tBE, and tCE in AC Characteristics). When the program, erase or write status register

instruction has completed, the BUSY bit will be cleared to a 0 state indicating the device is ready for

further instructions.

8.1.2 Write Enable Latch (WEL)

Write Enable Latch (WEL) is a read only bit in the status register (S1) that is set to a 1 after executing

a Write Enable Instruction. The WEL status bit is cleared to a 0 when the device is write disabled. A

write disable state occurs upon power-up or after any of the following instructions finished: Write

Disable, Page Program, Sector Erase, Block Erase, Chip Erase and Write Status Register.

8.1.3 Block Protect Bits (BP1, BP0)

The Block Protect Bits (BP1 and BP0) are non-volatile read/write bits in the status register (S3 and S2)

that provide Write Protection control and status. Block Protect bits can be set using the Write Status

protected from Program and Erase instructions (see Status Register Memory Protection table). The

factory default setting for the Block Protection Bits is 0, none of the array protected. The Block Protect

bits cannot be written to if the Status Register Protect (SRP) bit is set to 1 and the Write Protect (/WP)

pin is low.

8.1.4 Top/Bottom Block Protect (TB)

The Top/Bottom bit (TB) controls if the Block Protect Bits (BP1, BP0) protect from the Top (TB=0) or

the Bottom (TB=1) of the array as shown in the Status Register Memory Protection table. The TB bit is

non-volatile and the factory default setting is TB=0. The TB bit can be set with the Write Status

written to if the Status Register Protect (SRP) bit is set to 1 and the Write Protect (/WP) pin is low.

W25X05CLZPIG bảng dữ liệu(PDF) 10 Page - Winbond