W25Q32FVZPIP datasheet(61/99 Pages) WINBOND

61 / 99 page

W25Q32FV

Publication Release Date: Sept 16,, 2013

- 60 -

Revision H

8.2.24

Release Power-down / Device ID (ABh)

The Release from Power-down / Device ID instruction is a multi-purpose instruction. It can be used to

release the device from the power-down state, or obtain the devices electronic identification (ID) number.

To release the device from the power-down state, the instruction is issued by driving the /CS pin low,

shifting the instruction code “ABh” and driving /CS high as shown in Figure 38a & 38b. Release from

power-down will take the time duration of tRES1 (See AC Characteristics) before the device will resume

normal operation and other instructions are accepted. The /CS pin must remain high during the tRES1 time

duration.

When used only to obtain the Device ID while not in the power-down state, the instruction is initiated by

driving the /CS pin low and shifting the instruction code “ABh” followed by 3-dummy bytes. The Device ID

bits are then shifted out on the falling edge of CLK with most significant bit (MSB) first. The Device ID

value for the W25Q32FV is listed in Manufacturer and Device Identification table. The Device ID can be

read continuously. The instruction is completed by driving /CS high.

When used to release the device from the power-down state and obtain the Device ID, the instruction is

the same as previously described, and shown in Figure 38c & 38d, except that after /CS is driven high it

must remain high for a time duration of tRES2 (See AC Characteristics). After this time duration the device

will resume normal operation and other instructions will be accepted. If the Release from Power-down /

Device ID instruction is issued while an Erase, Program or Write cycle is in process (when BUSY equals

1) the instruction is ignored and will not have any effects on the current cycle.

/CS

CLK

(IO

Mode 0

Mode 3

Instruction (ABh)

Mode 0

Mode 3

tRES1

Power-down current

Stand-by current

Figure 38a. Release Power-down Instruction (SPI Mode)

W25Q32FVZPIP bảng dữ liệu(PDF) 61 Page - Winbond