AMC7812SPAPR datasheet(41/92 Pages) TI

41 / 92 page

AMC7812

www.ti.com

SBAS513E – JANUARY 2011 – REVISED SEPTEMBER 2013

DAC Output

The output range is programmable from 0 to (2 · VREF) or from 0 to (5 · VREF), depending on the gain bits in the

DAC Gain Register. The maximum output is AVCC. The output buffer amplifier is capable of generating rail-to-rail

voltages on its output, giving an output range of 0V to AVCC. The source and sink capabilities of the output

amplifier can be seen in the Typical Characteristics. The slew rate is 1.5V/

μs with a typical ¼ to ¾ scale settling

time of 3

μs with the output unloaded.

Double-Buffered DAC Data Registers

There are 12 double-buffered DAC data registers. Each DAC has an internal latch preceded by a DAC Data

DAC-n Latch. When the DAC-n Latch is updated, the output of DAC-n changes to the newly set value. When the

host reads the register memory map location labeled DAC-n Data, the value held in the DAC-n Latch is returned

(not the value held in the input DAC-n-Data Register).

Full-Scale Output Range

The full-scale output range of each DAC is set by the product of the value of the reference voltage times the gain

of the DAC output buffer (VREF · Gain). The gain bits of the DAC Gain Register set the output range of the

individual DAC-n. The full-scale output range of each DAC is limited by the analog power supply. The maximum

output from the DAC must not be greater than AVCC, and the minimum output must not be less than AGND.

DAC Output After Power-On Reset

After power on, the DAC output buffer is in power-down mode. The output buffer is in a Hi-Z state and the DAC-

Out output pin connects to the analog ground through an internal 10k

Ω resistor. After power on or hardware

reset, all DAC-n-Data Registers, all DAC-n Latches, and the DAC output are set to default values (000h).

Load DAC Latch

See Figure 91 for the structure of the DAC register and DAC latch. The contents of the DAC-n Latch determine

the output level of the DAC-n pin. After writing to the DAC-n-Data Register, the DAC Latch can be loaded in the

following ways:

•

In asynchronous mode (SLDAC-n bit = '0'), the data are loaded into the DAC-n Latch immediately after the

write operation.

•

In synchronous mode (SLDAC-n bit = '1'), the DAC latch updates when the synchronous DAC loading signal

occurs. Setting the ILDAC bit in AMC Configuration Register 0 generates the loading signal.

Submit Documentation Feedback

Product Folder Links: AMC7812

AMC7812SPAPR bảng dữ liệu(PDF) 41 Page - Texas Instruments