STM32F100RC datasheet(21/98 Pages) STMICROELECTRONICS

21 / 98 page

STM32F100xC, STM32F100xD, STM32F100xE

Description

Doc ID 15081 Rev 7

21/98

This dual digital Interface supports the following features:

●

two DAC converters: one for each output channel

●

up to 10-bit output

●

left or right data alignment in 12-bit mode

●

synchronized update capability

●

noise-wave generation

●

triangular-wave generation

●

dual DAC channels’ independent or simultaneous conversions

●

DMA capability for each channel

●

external triggers for conversion

●

input voltage reference VREF+

Eight DAC trigger inputs are used in the STM32F100xx. The DAC channels are triggered

through the timer update outputs that are also connected to different DMA channels.

2.2.26

Temperature sensor

The temperature sensor has to generate a voltage that varies linearly with temperature. The

conversion range is between 2 V < VDDA < 3.6 V. The temperature sensor is internally

connected to the ADC1_IN16 input channel which is used to convert the sensor output

voltage into a digital value.

2.2.27

Serial wire JTAG debug port (SWJ-DP)

The ARM SWJ-DP Interface is embedded, and is a combined JTAG and serial wire debug

port that enables either a serial wire debug or a JTAG probe to be connected to the target.

The JTAG TMS and TCK pins are shared respectively with SWDIO and SWCLK and a

specific sequence on the TMS pin is used to switch between JTAG-DP and SW-DP.

STM32F100RC bảng dữ liệu(PDF) 21 Page - STMicroelectronics