EM357-MOD-RF-T datasheet(43/43 Pages) SILABS

43 / 43 page

8-5

EM35x Development Kit User Guide

120-4030-000E

8.6

Programming Manufacturing Tokens

The em3xx_load utility has the ability to program manufacturing tokens much like the em2xx_patch tool did. In

the case of the EM357, these tokens are contained in the Customer Information Block(CIB). For more

information on using the em3xx_load utility, refer to document 120-4032-000, EM3xx Utilities Guide.

8.6.1

Programming Certificates & Installation Codes

Certificates and installation codes can be programmed using the same em3xx_load tool that is used to program

other tokens. There is a separate application note which describes the process in detail. For more information,

see document 120-5058-000, Setting Manufacturing Certificates and Installation Codes.

8.7

Using the Debugger in IAR Embedded Workbench with an Ember

InSight Adapter

Start IAR Embedded Workbench. Open the workspace (*.eww).

Select Project > Options. Select the Debugger > J-Link/J-Trace category. Select the Connection tab.

Select TCP/IP Communication and enter the IP address of the ISA3. Click OK.

Embedded Workbench is not able to program the flash on the EM357. Every time the project is re-

built, you must manually load it onto the EM357 (using em3xx_load.exe) before starting a debug

session.

Once the correct image has been loaded onto the EM357, select Project > Debug without Downloading

to start the debug session.

EM357-MOD-RF-T bảng dữ liệu(PDF) 43 Page - Silicon Laboratories