TMP320C6720RFP300 datasheet(45/118 Pages) TI

45 / 118 page

4.11 External Memory Interface (EMIF)

4.11.1 EMIF Device-Specific Information

TMS320C6727B, TMS320C6726B, TMS320C6722B, TMS320C6720

Floating-Point Digital Signal Processors

www.ti.com

SPRS370E – SEPTEMBER 2006 – REVISED JULY 2008

The C672x DSP includes an external memory interface (EMIF) for optional SDRAM, NOR FLASH, NAND

FLASH, or SRAM. The key features of this EMIF are:

• One chip select (EM_CS[0]) dedicated for x16 and x32 SDRAM (x8 not supported)

• One chip select (EM_CS[2]) dedicated for x8, x16, or x32 NOR FLASH; x8, x16, or x32 Asynchronous

SRAM; or x8 or x16 NAND FLASH

• Data bus width is 16 bits on the C6726B, C6722B, and C6720; and 32 bits on the C6727B.

• SDRAM burst length of 16 bytes

• External Wait Input on the C6727B through EM_WAIT (programmable active-high or active-low)

• External Wait pin functions as an interrupt for NAND Flash support

• NAND Flash logic calculates ECC on blocks of up to 512 bytes

• ECC logic suitable for single-bit errors

Figure 4-5 and Figure 4-6 show typical examples of EMIF-to-memory hookup on the C672x DSP.

As the figures illustrate, the C672x DSP includes a limited number of EMIF address lines. These are

sufficient to connect to SDRAM seamlessly. Asynchronous memory such as FLASH typically will need to

use additional GPIO pins to act as upper address lines during device boot up when the FLASH contents

are copied into SDRAM. (Normally, code is executed from SDRAM since SDRAM has faster access

times).

Any pins listed with a ‘Y' in the GPIO column of Table 2-12 may be used for this purpose, as long as it can

be assured that they be pulled low at (and after) reset and held low until configured as outputs by the

DSP.

Note that EM_BA[1:0] are used as low-order address lines for the asynchronous interface. For example, in

Figure 4-5 and Figure 4-6, the flash memory is not byte-addressable and its A[0] input selects a 16-bit

value. The corresponding DSP address comes from EM_BA[1]. The remaining address lines from the

DSP (EM_A[12:0]) drive a word address into the flash inputs A[13:1].

For a more detailed explanation of the C672x EMIF operation please refer to the document

TMS320C672x External Memory Interface (EMIF) User's Guide (literature number SPRU711).

Submit Documentation Feedback

Peripheral and Electrical Specifications

TMP320C6720RFP300 bảng dữ liệu(PDF) 45 Page - Texas Instruments