ATmega1284P datasheet(313/380 Pages) ATMEL

313 / 380 page

313

8059D–AVR–11/09

ATmega1284P

25.10.8

Reset Register

The Reset Register is a Test Data Register used to reset the part during programming. It is

required to reset the part before entering Programming mode.

A high value in the Reset Register corresponds to pulling the external reset low. The part is reset

as long as there is a high value present in the Reset Register. Depending on the Fuse settings

for the clock options, the part will remain reset for a Reset Time-out period (refer to ”Clock

Sources” on page 28) after releasing the Reset Register. The output from this Data Register is

not latched, so the reset will take place immediately, as shown in Figure 23-2 on page 268.

25.10.9

Programming Enable Register

The Programming Enable Register is a 16-bit register. The contents of this register is compared

to the programming enable signature, binary code 0b1010_0011_0111_0000. When the con-

tents of the register is equal to the programming enable signature, programming via the JTAG

port is enabled. The register is reset to 0 on Power-on Reset, and should always be reset when

leaving Programming mode.

Figure 25-14. Programming Enable Register

25.10.10 Programming Command Register

The Programming Command Register is a 15-bit register. This register is used to serially shift in

programming commands, and to serially shift out the result of the previous command, if any. The

JTAG Programming Instruction Set is shown in Table 25-18 on page 315. The state sequence

when shifting in the programming commands is illustrated in Figure 25-16 on page 318.

TDI

TDO

ClockDR & PROG_ENABLE

Programming Enable

0xA370

ATmega1284P bảng dữ liệu(PDF) 313 Page - ATMEL Corporation