ATmega1284P datasheet(309/380 Pages) ATMEL

309 / 380 page

309

8059D–AVR–11/09

ATmega1284P

Notes:

1. Not all instructions are applicable for all parts.

2. a = address.

3. Bits are programmed ‘0’, unprogrammed ‘1’.

4. To ensure future compatibility, unused Fuses and Lock bits should be unprogrammed (‘1’) .

5. Refer to the correspondig section for Fuse and Lock bits, Calibration and Signature bytes and

Page size.

6. Instructions accessing program memory use a word address. This address may be random

within the page range.

7. See htt://www.atmel.com/avr for Application Notes regarding programming and programmers.

If the LSB in RDY/BSY data byte out is ‘1’, a programming operation is still pending. Wait until

this bit returns ‘0’ before the next instruction is carried out.

Within the same page, the low data byte must be loaded prior to the high data byte.

After data is loaded to the page buffer, program the EEPROM page, see Figure 25-11 on page

309.

Figure 25-11. Serial Programming Instruction example

Byte 1

Byte 2

Byte 3

Byte 4

Adr LSB

Bit 15 B

Serial Programming Instruction

Program Memory/

EEPROM Memory

Page 0

Page 1

Page 2

Page N-1

Page Buffer

Write Program Memory Page/

Write EEPROM Memory Page

Load Program Memory Page (High/Low Byte)/

Load EEPROM Memory Page (page access)

Byte 1

Byte 2

Byte 3

Byte 4

Bit 15 B

Adr MSB

Page Offset

Page Number

Adr M

Adrr L

LSB

ATmega1284P bảng dữ liệu(PDF) 309 Page - ATMEL Corporation

ATmega1284P bảng dữ liệu(HTML) 309 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL