ATmega1284P datasheet(52/380 Pages) ATMEL

tên linh kiện	ATmega1284P

Giải thích chi tiết về linh kiện	8-bit Microcontroller with 128K Bytes In-System Programmable Flash

PDF	380 Pages

Scroll/Zoom	100%

nhà sản xuất	ATMEL [ATMEL Corporation]

Trang chủ	http://www.atmel.com

Logo

52 / 380 page

8059D–AVR–11/09

ATmega1284P

9.2

Internal Voltage Reference

ATmega1284P features an internal bandgap reference. This reference is used for Brown-out

Detection, and it can be used as an input to the Analog Comparator or the ADC.

9.2.1

Voltage Reference Enable Signals and Start-up Time

The voltage reference has a start-up time that may influence the way it should be used. The

start-up time is given in ”System and Reset Characteristics” on page 327. To save power, the

reference is not always turned on. The reference is on during the following situations:

When the BOD is enabled (by programming the BODLEVEL [2:0] Fuse).

When the bandgap reference is connected to the Analog Comparator (by setting the

ACBG bit in ACSR).

When the ADC is enabled.

Thus, when the BOD is not enabled, after setting the ACBG bit or enabling the ADC, the user

must always allow the reference to start up before the output from the Analog Comparator or

ADC is used. To reduce power consumption in Power-down mode, the user can avoid the three

conditions above to ensure that the reference is turned off before entering Power-down mode.

ATmega1284P bảng dữ liệu(PDF) 52 Page - ATMEL Corporation