ATmega1284P datasheet(222/380 Pages) ATMEL

222 / 380 page

222

8059D–AVR–11/09

ATmega1284P

Figure 19-13. Data Transfer in Master Receiver Mode

A START condition is sent by writing the following value to TWCR:

TWEN must be written to one to enable the 2-wire Serial Interface, TWSTA must be written to

one to transmit a START condition and TWINT must be set to clear the TWINT Flag. The TWI

will then test the 2-wire Serial Bus and generate a START condition as soon as the bus

becomes free. After a START condition has been transmitted, the TWINT Flag is set by hard-

ware, and the status code in TWSR will be 0x08 (See Table 19-2 on page 220). In order to enter

MR mode, SLA+R must be transmitted. This is done by writing SLA+R to TWDR. Thereafter the

TWINT bit should be cleared (by writing it to one) to continue the transfer. This is accomplished

by writing the following value to TWCR:

When SLA+R have been transmitted and an acknowledgement bit has been received, TWINT is

set again and a number of status codes in TWSR are possible. Possible status codes in Master

mode are 0x38, 0x40, or 0x48. The appropriate action to be taken for each of these status codes

is detailed in Table 19-3 on page 223. Received data can be read from the TWDR Register

when the TWINT Flag is set high by hardware. This scheme is repeated until the last byte has

been received. After the last byte has been received, the MR should inform the ST by sending a

NACK after the last received data byte. The transfer is ended by generating a STOP condition or

a repeated START condition. A STOP condition is generated by writing the following value to

TWCR:

A REPEATED START condition is generated by writing the following value to TWCR:

After a repeated START condition (state 0x10) the 2-wire Serial Interface can access the same

Slave again, or a new Slave without transmitting a STOP condition. Repeated START enables

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

Device 1

MASTER

RECEIVER

Device 2

SLAVE

TRANSMITTER

Device 3

Device n

SDA

SCL

........

ATmega1284P bảng dữ liệu(PDF) 222 Page - ATMEL Corporation

ATmega1284P bảng dữ liệu(HTML) 222 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL